Insulation Load Spreading Retaining Washer
88
views
2
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments... 
Insulation Load Spreading Retaining Washer
Published 2020-11-24T11:25:34+00:00
2
0
Add to Collection
Description
Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
Licence
Détail de l'impression
### Supports
no
### Resolution
0.3
### Infill
20
### Misc Notes
Print without supports by moving 1mm below the build plate (z-axis -1mm).
Technical Information
| Date de publication | 24/11/2020 |
| Durée d’impression | 25 - minutes |
| Dimensions | 59.69mm x 59.69mm x 59.69mm |
More Information
Object Parts
