Key-Tags
Key-Tags
Published 2020-09-18T09:51:54+00:00
Key-tags for all the 3d printing enthusiasts. Made as two halves to be glued together forming one however they don't look bad separately either. This was made on an Ender-3 pro rather than my Flashforge Creator 3, shows that there's no excuses for the quality of a print.
I did the different colors with a cura setting called 'filament change'. These key-tags are all the same height so the setting should be the same at whatever height you change filament. I changed filament at layer 8 and again at layer 15. This can also be done with a duel extruder at a height of 1.6 mm and again at 3 mm. Keep in mind I printed on 0.2 layer height and chose specific layer numbers for this purpose.
| Date de publication | 18/09/2020 |
| Dimensions | 0mm x 0mm x 0mm |
| Sans support | YES |