Low poly bear head
Low poly bear head
3D
Published 2020-01-03T15:45:14+00:00
low poly bear head in obj
Updated file - 06.01.2020
Can be hung on the wall as a decor
The model is prepared for 3D printing, I was printing on a fdm 3d printer made of plastic gray plastic. 0.8 mm nozzle to speed up the process. Support is included because teeth and hair hang down and may not print without them.
The dimensions of the model are shown in the photo in the application (units of mm)
It took me 12 hours to print a full-size model (print speed 60 mm / s), nozzle 0.8 mm, layer 0.2 mm, 2 perimeters and 10% filling alternating through the layer (i.e. to fill the layer height 0 , 4 mm, as well for the support)
the weight of the product is 504 grams, given that the price of 1 kg of plastic costs 800 rubles - the bear's head went for about 400 rubles based on materials
If you did not like this model or there is something wrong with it, write about it in the comments
Updated file - 06.01.2020
I added a mount for a self-tapping screw or dowel with a cap diameter of up to 9 mm (I used a 4 mm screw with a length of 30 mm - its cap is 8 mm)
Attention !!! if you change the scale, the mount will not work, since when you reduce the model, the mount size will change
If you decide to resize, I attached the mount file in the STL format - you will need to place it in the desired location and subtract using the Boolean operation in any editor that supports this
1 part - 1 head 8) no fix
2 part - fix for boolean (useful if you change the size of the model)
3 part - low poly bear head with mount
It is advisable to print with a large diameter nozzle; to get a good surface, it is better to use a layer of minimum height / to reduce printing time, use a layer equal to half the diameter of the nozzle
I used support for the teeth of the upper jaw and hair, cool air to the maximum, PLA likes cold
| Date de publication | 03/01/2020 |
| Durée d’impression | 720 - 720 minutes |
| Quantité de filament | 504g |
| Dimensions | 168 x 198 x 186 mm |
