Minimal Headphone Stand - Rev 2
Minimal Headphone Stand - Rev 2
3D
Published 2017-06-05T17:12:03+00:00
This is a headphone stand you can print in less than 5.5 hours, 150 grams of material (or less depending on infill), and with no supports. It will also test your printing calibration a bit, containing overhangs, bridges, and very little bed contact. The part was designed to be printed in an orientation that would optimize the strength of the part, so print it in the orientation shown in the picture.
Check out the video and subscribe to my channel if you're into it! : https://www.youtube.com/watch?v=x81h09H-L8E&feature=youtu.be
Also, feel free to join my Facebook page to get extra content. I post prototypes and extra parts that I don't film for YouTube: https://www.facebook.com/3dprintingengineer/
For best strength, print with 4 shells. Infill doesn't matter much since the shells will create more than 95% of the part by volume. Print in the orientation shown in the screenshot of Cura. Any acceptable layer height should work.
So far i've only tested this in Proto-Pasta HTPLA V3, but it should work with any material.
| Date de publication | 05/06/2017 |
| Durée d’impression | 320 - 360 minutes |
| Quantité de filament | 150g |
| Dimensions | 200x240x220 |
| Technologie | FDM |
| Complexité | Medium |
| Sans support | YES |
