New Zealand Racer
New Zealand Racer
3D
Published 2014-03-04T19:17:52+00:00
Model Catermaran, with working sails and steering, this model is designed to float and you will have hours of fun at your local pond
Print all the pieces in a high resolution, ABS plastic works best and it will need a few coats of clear lacquer to water proof the hull, ( I recommend printing at the best resolution for the two hulls ). The catamaran has to be very light to float well , so print all the pieces with the lowest internal fill, except piece 1 and the front sail (highest internal fill), since they balance the weight and shift the center of gravity of the boat.
It is best to print the pieces using a single type/colour of filiament, and then spray the parts with your favourite colours, the printing will be more exact by using the same filament for all the parts.
Put a lot of glue between the pieces of the sails, the hulls and the other pieces of the catamaran; you can use a UHU waterproof glue for the the hulls and the other pieces likely to come in contact with water, and a super glue for the sails.
| Date de publication | 04/03/2014 |
| Dimensions | 60 cm / 28 cm / 18 cm |
| Complexité | Medium |