Paracord Cord Locks for use with Covid-19 Masks and other things
Paracord Cord Locks for use with Covid-19 Masks and other things
3D
Published 2020-04-14T11:53:38+00:00
This is a cord lock for using Paracord with the Montana Mask and others. I talked to the hospital and their biggest gripe was that the mask doesn't hold to the wearers face properly. I designed these cord locks to tighten the mask against the face so much so you can't even get your finger under it to scratch. These should be printed upright. I have only included the stacked models. I used 20 inches of paracord per loop and finished the loop ends with a zip tie to be zip tied to the mask. Please read the printing details below
Print these in .3 layers with print thin walls turned on. For proper bed adheasion I used a 4mm brim. When these finish printing, they just snap apart. I have included 4 different diameter "gears" to be used with different quality paracords (the stuff from the dollar store needs a bigger lock than does the stuff from Home Depot.). Print all 4 to test what size you need with the cord you have. After printing and assembling the cords I used a soldering iron to melt the top to the bottom in 4 spots where the edge of the top and the flat of the bottom meet. I have included files for 2 at a time and 160 at a time. the 160 at a time files fit on a 220x220 bed
| Date de publication | 14/04/2020 |
| Sans support | YES |