This case was made to solve a probleme I have.... no patience. At the time of receipt of my Pi Zero I was going to get the Zero4u addition but Adafruit (I love those guys) was out of them and i needed the power and usb to go with my zero. I stumbled across the Insignia 4 port usb hub at the electronics store and it comes with a 5 volt 2 amp power brick with it. Now i had the power the ports but too cumbersome so. I designed this case as just a way to clean up the clutter but it works and i hope it works for you too.
Model number of the hub is NS-PCH5421
There is some soldering if you care to do it and i would suggest a jst connector in between the hub and the zero. I didnt but could see how it would make life simpler.
Printed at 238 deg C 60 mms .2mm height for the box and .1 mm height for the lid. 45 degree slant for the xy direction but flat on the face for both the 45 degree is to keep bothe axis of my printer moving to take out zome wobble. The lid when uploaded into your slicer will have to be rotated to its face 90 deg.
Printer: Anet a8 in bad need of teardown clean and tighten and with settings still produced a workable piece that you see here.
There will be a video attached to the discription soon but i worry it will be longer than the time it took you to read this.
I know it will.