Raspberry Pi Case - Very Slim design
Raspberry Pi Case - Very Slim design
Published 2018-05-01T10:57:20+00:00
I just recently purchased my Raspberry Pi and 3.2 touchscreen and wanted to protect it. I designed this to be a custom fit for the two parts. If you decide to use this design, I do have two suggestions for you. When assembling it, the board should slide under the little "shelf steps" on the Base model and it will be easier to install the Raspberry Pi board first without the screen attached and then insert the screen. The screen should then rest on the little shelf printed along the top of the Base model on one side. When installing the cover and if you use screws to hold it together, make sure the screw on the end isn't too long. Otherwise, it will go through and touch/damage the touchscreen plug.
I made this out of regular PLA, but I can only assume that any material will work. You only need support material on the two little "shelves" on the Base model. All of the holes should print okay without support.
Date de publication | 01/05/2018 |
Technologie | FDM |
Complexité | Easy |