Rigid Fibre Guide Bar for Markforged
996
views
19
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Rigid Fibre Guide Bar for Markforged
3D
Published 2020-08-17T21:50:18+00:00
1
0
Add to Collection
Description
This part fits over the magnetic end cap for the reinforcement fiber roll for a markforged printer (Tested on Mark 1). The cross bar stops the rigid fibre from exploding out, and the nub on the bottom stops any reciprocal flexure on the opposite end from slipping over the side.
I've been printing with carbon fiber as the reinforcement fiber on a Markforged Mark 1 recently, and I can't turn around for 2 seconds before this rigid fiber flies off the spool and wilds out into the build volume like someone just opened a can of peanut brittle only to find that it was full of spring-loaded snakes! I slapped this on my spool, and now I have no more problems with it.
Licence
Technical Information
Date de publication | 17/08/2020 |
Sans support | YES |
More Information
Object Parts