Did you ever want to drive on snow or ice with your RC-car? With this design you will be able to drive on rougher and slickier terrain!

Just print out the part as often as you need it (I needed around 20 of them per wheel with a diameter of 10 cm).

Basically you can use it for any car but if the wheels of your car are smaller I recommend scaling the object down (in the slicer). Once they are printed simply click them together in one of the following setups:

• a chain around each wheel
• a chain around two wheels at once (similar to the chains of diggers or tanks)

Then just have fun!

In case the snow chains slide to the side you can secure it with some tape.