Solar Power Swinging Whale
Solar Power Swinging Whale
3D
Published 2017-03-28T15:37:27+00:00
Like solar powered things? Like swinging things? Like whales? Like solar powered swinging whales? Well if you answered yes to all of the previous questions, then the Solar Power Swinging Whale is for you.
Video of prototype at http://www.youtube.com/watch?v=nHj41gYe0D4.
You'll need to purchase one of those solar powered hula girls, snowman, devil, etc. (I used the devil) found at the dollar store (for a dollar), or on the web.
You'll also need a 12mm by 3mm magnet, and some sewing thread.
Designed using Sketchup 8, and printed in PLA on a Makerbot Replicator 2 using Makerware 2.3.3.42 "Standard" settings except for "Whale.stl", which was printed with 0% infill.
Study "Assembly.skp" before proceeding (it can be viewed with the free version of Sketchup 8).
Carefully remove the base from the solar powered devil (or hula girl, snowman, etc.). Once removed, I placed a dot of cyanoacrylate glue on each end of the solar panel to hold it in place.
Print "Base.stl", and fit it over the solar powered base, such that the solar panel tower protrudes through the rectangle in "Base.stl".
Print "Riser.stl".
Print "Solar Cover.stl". Slide "Riser.stl" into slot in "Solar Cover.stl".
Slide the "Solar Cover.stl" and "Riser.stl" assembly over the solar panel tower.
Print "Whale.stl".
Press the magnet between the fins of "Whale.stl", just enough to hold it in place.
Run thread from "Riser.stl", through the eyelet on top of "Whale.stl", then back to "Riser.stl". Adjust the length of the thread such that the magnet is 1 to 2mm above the top surface of "Base.stl" and nothing drags.
Turn on the lights and watch it swing.
| Date de publication | 28/03/2017 |
| Technologie | FDM |