Spool holder
2,683
views
144
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Spool holder
3D
Published 2018-07-05T22:12:15+00:00
7
0
Add to Collection
Description
This is a high-quality spool holder I designed for my own use but upon realising how useful this could be for others I have published it.
Notes
If your spool is too large, remove the bottom rods as these are for extra support.
Assembly
Slide the large rod into the top hole of one frame, repeat this with the smaller rods on the same frame. Add the spool so that the center gap has the large rod going through it. Place the second frame on top of the rods and push it down. Now, position the rods so that the frames are in between the sticking out rectangles, at this point rotate the rods ninety degrees. Now you are done!
Détail de l'impression
You will need to print
- Frame 1 (1X)
- Frame 2 (1X)
- Large Rode (1X)
- Small Rod (2X)
Technical Information
Date de publication | 05/07/2018 |
Durée d’impression | 1 - 2 minutes |
Dimensions | 140mm x 127mm x 5.850mm |
More Information
Object Parts