TWA Moonliner - Rocket to the Moon
TWA Moonliner - Rocket to the Moon
3D
Published 2019-05-30T18:30:53+00:00
"Welcome aboard, friends. This is Captain Collins speaking...."
---------------
The Original Rocket to the Moon
When Disneyland's Tomorrowland opened in 1955, the centerpiece attraction was the Rocket to the Moon, sponsored by TWA (Trans-World Airlines). Situated at the rear of the land, the massive Moonliner rocket ship in front of the attraction worked as a "weenie," drawing guests deeper into the Tomorrowland.
What they found was an experience beyond belief. Guests "entered" the rocket. Using projections on both the floor and ceiling in a theater in the round, the Rocket to the Moon transported guests to a place they could only dream of: space. Aboard the rocket ship "Star of Polaris," Disneyland's visitors made the trek past the space station Terra, then around the moon and back.
The Moonliner was designed by Imagineer John Hench, with guidance from former-Nazi rocket scientist Wernher von Braun. Von Braun - hired by Walt Disney to imagine how human space flight could be possible - helped keep the fanciful plans for spaceships more deeply grounded in the possible. The Moonliner imagined a future - the year 1986 - when civilian spaceflight would be a normal, everyday occurrence.
Von Braun also worked on the Disneyland television series, appearing in the 1955 episodes "Man in Space" and "Man and the Moon." These films were shown to American President Eisenhower and Soviet Commissioner for Spaceflight Leonid Sedov, helping to kickstart the worldwide dreams of putting man in space.
Printing the Model
This model is inspired by the original Moonliner which rose above the Disneyland skyline - the tallest object in Disneyland when it opened in 1955. The model is designed roughly at HO scale (1:87) in a number of parts to enable easy printing.
You will need to print one main body; three each of the legs, feet, and supports; and four of the fins. The body of the rocket should print well vertically without supports. You will likely be able to print the other elements without supports depending on orientation. The fins are designed to be attached to the exhaust port with a small length of 1.75mm filament as a pin if the model is printed at scale.
The model has been tested on an Ender 3 and prints nicely at scale without supports. Fittings are slightly loose, so a dab of cyanoacrylate might be needed to hold the model together. Included is a STL of the plated model I was able to successfully print.
This model was based on the original brownline plans for the Disneyland rocket, which have been sold in fan auctions a number of times. See these examples from Van Eaton Gallery:
https://www.icollector.com/Pair-of-TWA-Rocket-Brownlines-with-Notes_i27326056
This models was designed and fine-tuned in TInkercad:
https://www.tinkercad.com/things/d05XGjTLMbf-twa-moonliner-complete-model
| Date de publication | 30/05/2019 |
| Sans support | YES |