Ultimaker2 plug support and filament guide
Ultimaker2 plug support and filament guide
3D
Published 2015-07-28T12:22:44+00:00
If you have ever felt like your power cable would be pulled or switch flipped during the middle of a long print this is the addon for you. Combining a plug support, power switch bumper, and filament guide its a three in one miracle. This print will help prevent pulled plugs, bumped switches, and provides an alternative for people who are using off machine spool holders.
my print time was about 4hrs with 6meters used.
You will need some hardware to assemble this print.
Two 4mm and three 3mm screws, but I've left enough material that you could get away with various sizes of screws. Test as needed.
Also, while not necessary I've added a sleeve for a 21mm scooter wheel bearing. You could just use the post already in the print if you don't have that.
Using an ultimaker 2 with 3mm abs filament. print settings; .2mm layer height .8 shell thickness 20% grid infill 15 lines of brim no support needed* *some may find the bearing sleeve difficult to print without support and at that point you would need everywhere support at 45 degrees.
| Date de publication | 28/07/2015 |
| Durée d’impression | 180 - 270 minutes |
| Quantité de filament | 33g |
| Dimensions | 4 parts |
| Technologie | FDM |
| Complexité | Easy |
