UV Cure Chamber
UV Cure Chamber
Published 2020-11-13T14:46:42+00:00
Notes:
All Parts will interlock, can be held together with small nails or tiny screws at verticals while glue cures, I used Gorilla Super glue Gel with spray activator. Filler panels are from 1/8" modeling plywood. hinge is 3/32 alum rod, just what I found at the hobby store that day. Small angles are to make the UV led strip lay down easier, I ended up using hot glue to perm mount them (2 strips per vertical). Large angle are to give more reflective angles for coverage. covered all internal surfaces except vertical rails with aluminum tape for reflection. Also covered top of table with tape to allow reflection up into the model. All wires were routed thru bottom and spliced together in empty bottom base then receptacle mounted to side so I could just plug in the power and let it go. You will need 5 verticals, 2 bases for top & bottom, 1 UV Base, 2 hinge lines, 1 door center, 2 door caps, 8 Large angles, 10 small angles. 1 roll of UV lights ($17 with power supply on Amazon),1 3/32 rod( 2.3mm). Light powered display base, Aluminum tape(or something reflective) Each of my 10 light strips I wired up in parallel then attached the supplied receptacle maintaining polarity in the base.
Date de publication | 13/11/2020 |
Sans support | YES |