This is my take on the single edged Viking sword. It was based on The bezerker from Albion Swords. 

Please read descrition for instructions!

To Contruct this print has will need a wooden plank (3mmX24mmX164) for sword 9-2, A wodden dowl (dia 6mm X lenght 100mm) for sword 2-1, and a nut and bolt (dia 6mmX40mm) bolt imbedded in the end of sword 1. There is a distiled taper on the blade. As such to put them together in the right oreantation, place the two faces together, if they fit flush with eachother they're in the proper oreantation, and if the face it too small then it's the either the wrong peice or wrong side. 

To imbed the bolt, check the preview for sword 1 on your softwear. From there you can see where the printer starts to fill up the top of the hole. When you've started the print, wait for just before it reaches that point and pause the print so you can put in the bolt then continue the print, locking it in place. 

Supports are needed for the guard, handle, pommel, and holder peices only. Sword 1 doesn't need suports as it's meant to house an imbedded peice.