JetPrints's Print of Spin Vase 4
Community Print Impression 3D de Spin Vase 4
Published 2018-10-27T12:30:37+00:00
0
0
Printed on: Raise3D N2
Material: PLA
Description
Printed with a 0.8mm nozzle, 1.2mm extrusion width and 0.4mm layer height. This is 3dFuel PLA. I printed it at 210 and 25mm/s. the bottom layers are 2, obviously 0% infill and no top layers. I did notice the bottom layers arent well "connected" and there are holes. I need to figure out how to off set that, whether its increasing the flow to 105% or something else.