Anet A6 Stabilising Struts and Base Clamp
1,410
views
42
downloads
0 comments
Loading comments...
Anet A6 Stabilising Struts and Base Clamp
3D
Published 2020-01-10T16:05:10+00:00
4
0
Add to Collection
Description
These struts are designed to stabilise the Anet A6 and to prevent it moving on its bench.
I found that after adding more tension to the Y Belt that the whole printer would "flex" forward. To fix this I added these 8mm threaded struts which keep the frame square and hold the printer in the correct position at all times.
These have saved me a fair bit of bed levelling by stabilising the positions of the uprights relative to the Y axis front belt plate.
Each 8mm threaded strut is about 40cm long but I would advise buying a 1m length and cutting to the right length in place after bolting everything up.
Licenza
Technical Information
Date published | 10/01/2020 |
More Information
Object Parts