AnyStrap v.2
AnyStrap v.2
3D
Published 2020-04-25T01:10:15+00:00
Here is version 2 (plus iterations) of AnyStrap, this resolves some of the first issues I wanted to fix from version 1 which can be found here: https://www.myminifactory.com/object/3d-print-41165
In this design the buttons and holes are rounded making fastening them considerably easier, even with one hand... awkwardly. These are also thinner (1mm instead of 1.5mm+) making them more elastic (depending on material) and also eaiser to fasten. I made two different versions of spacing between holes and added one with just 2 buttons.
Currently they are just one length but I will add more lengths later. Recommendations of lengths are welcome. =]
See pictures for some basic fastening methods. I will be adding more as I take photos of the MANY uses for them.
I usually print these with 100% infill, but you can get more "stretchiness" if you use a lesser infill and thinner layers so you can still have a solid top and bottom.
In order to get adherence of the infill paths to fuse together properly I often need to print slower than recommended TPU speeds and end up down near 12 - 15mm/s, and an extrusion multiplier from 1.0 to 1.3 depending on filament. I'm sure if I tweaked the temp, extrusion multiplier, and cooling I could go fasters but I haven't taken the time to figure out all those settings just yet.
| Date published | 25/04/2020 |
| Tempo per farlo | 45 - 130 Minuti |
| Supporto Gratuito | YES |