Articulated Chameleon
Articulated Chameleon
3D
Published 2019-08-07T16:38:04+00:00
Articulated Chameleon with movable eyes!!
Interchangeable jaw, with or without a tongue. You choose!!
No supports required. Just slice and print!
Depending on your printer and slicer, the fit of the "jaw" or "jaw+tongue" with the head may be too loose or too tight. You can print them a bit smaller or larger with no problems (recommended from 95% to 105%, but can be even more).
Eyes
After printing, push the eyes until you hear a "click" or "pop" sound. That means now they are free to rotate. It may be hard to move the eyes at the beginning, but they become more free with the use.
Jaw / Jaw+Tongue
Depending on your printer and slicer, the fit with the head may be too loose or too tight. You can print them a bit smaller or larger as indicated above, or:
- If the tab is too tight, sand it a little bit.
- If the tab is too loose, you can "heat and squeeze" it to achieve a better fit. A hairdryer or even a lighter may do the job, and then press lightly with some pliers.
| Date published | 07/08/2019 |
| Supporto Gratuito | YES |
Five manual filament changes. No MMU.