Bed level test discs 180x180 x 0.2 mm - 1 to 9 points
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Bed level test discs 180x180 x 0.2 mm - 1 to 9 points
3D
Made for 220x220 or bigger beds, this level test discs use a square area of 180x180mm.
The discs have 0.2mm height and thus should be used with layer height of 0.2mm, you can then check the printed discs height to confirm if you the nozzle at the correct height.
Discs printed with values too lower than 0.2mm will cause elephant foot effect and discs printed with values higher than the 0.2mm may have adhesion problems.
The discs size is 20x20mm.
Enjoy and post your results!
| Status | Rejected |
| Supporto Gratuito | YES |