Big Top Bounce Mr. Teeth Target
$3.99 Big Top Bounce Mr. Teeth Target
3D
Published 2019-06-28T17:03:08+00:00
(This is a Big Top Bounce expansion game)
Uh oh! Looks like Mr. Teeth is due for the dentist but you left your tools at home! Can you complete the operation with just your handy dandy set of marbles?
SKILL LEVEL: Intermediate
Make sure to orient all prints so their flat surface is on the build plate. All pieces should be done with no supports.
The Tooth should be printed out 4 times. I would recommend using a brim to print them. Depending on your printer/filament, they may require some sanding after they come off the printer to best fit in Mr. Teeth's mouth. To install the teeth, orient them so that the surface that was on the print bed is facing out of his mouth and carefully snap them onto the pivot bar in his mouth. If they do not fall down easily, carefully remove them and sand them a little more. I find sanding the sides of the hooks that latch onto the pivot bar is the most effective.
I would also suggest printing the Ears Lift with a brim, and at a slightly higher infill to keep the part strong.
| Date published | 28/06/2019 |
| Price | $3.99 |
| Supporto Gratuito | YES |