Please enter the code below
Here's some kind of Cat/Catfolk/Tabaxi Mage/Wizard! Comes with a friendly rat familiar in paw! Will fit on a standard 25.4mm/1inch round Medium creature base.
Hope you enjoy it, this one was a lot of fun to sculpt.
(Bonus points if you can guess what show I had been watching to inspire the outfit~)
Support Me on Ko-fi
Test mini was printed at 0.08mm layer heights, 0.3mm wall thickness, with a 0.3mm nozzle. Slow and steady at .40mm/s, 40% underspeed at outer layers. +0.15 horizontal size compensation in S3D.
Make him a little bigger if printing with a .4mm nozzle to help with the smaller details.
Purrfect prints on Ender3/Cura stock! Turned staff into torch. Miles approves.