This is a completed Dalek Neck Ring and Head.
Listing can be found at the following locations.
Neck Rings : https://www.thingiverse.com/thing:2272856 https://www.myminifactory.com/object/39900
Dalek Head : https://www.thingiverse.com/thing:2271032 https://www.myminifactory.com/object/39893
8-12-2017: Just got done building and printing a 381 mm Lazy Suzy ring for the Dalek Head. This will allow you to mount and spin head with a 3/4 inch 3 inch long treaded rod.
You will need 113 bearings, depending on your 3d printer settings you might have to sand some bearings down.
I've added a Video of it working.
I've also added some upper and lower Platforms for the Dalek Head and Neck. Just glue in place and resin them. Both Head and Neck Platforms were made with 5% infill and 1mm top and bottom and side shell.
print them and fiberglass and resin them for extra strength.
The neck Platform I removed some sections so I can have easy access to remove and replace the HEAD Battery which will be 2 laptop batteries solder together.
When I get that far then I'll add photos of that.
8-6-2017: I've added some spacers so you can correctly place the rings together.
just use some Pipe cleaning wire to twist tie everything together, then Glue and Resin together.
you will need 4 spacers each at 20% infill or less. I made mine 20% infill with 1.2 mm top and bottom shell thickness
I'll be adding some extra inserts and platforms once I get the rest of the head together.
8/30/2017: as of today Dalek Ned's Head and neck are done.
They are 100% Printed material. including the light purple garments below his neck.