#TinkercadEaster This project is an easter toy that would be find inside the chocolate egg. It is so fun because the child and the adults have to assembly it before play with it. It's a tir that carries a big rabbit statue than can be turn by a crank handle situated in the back of the tir. To mount the toy first step is put toghether the back of it, there are six snap fit parts and I reccomend to pay attention to fit well all of them. Then you could mount the wheels with the two long posts, It will be so difficult to fit but It's because once fit It will remain in position. Then It's the turn of the crank handle, so you have to put the gearwheel in the squared hole in the back of the tir and at the same time put the long post with the crank handle into the hole of the back of the tir and then put it on the hole of the gearwheel. When you have do this put the large gearwheel in It's support in the back of the tir, than put the two small post in the holes of that, and then put the rabbits statue in the two posts.