NOTE: Still working on how to do this. This is actually the first time in my life that I can recall picking up a container of sparkles. Any suggestions from people with crafting experience are welcome. 1) Print something in ABS. 2) Vapor Polish 3) Remove from polishing bath 4) Shake on sparkles. This should be done when the surface is still almost liquidy. Alternatively, you could probably roll or dip into a bucket of sparkles. Or maybe put it into a bag and shake it around? 5) Allow solvent to fully evaporate. 6) Present thing to your favorite princess. 7) Bask in the glow of being the coolest dad or {insert whatever your relationship is here}. Print at 0.2 mm layer height, with 10% infill. This uses 44 g of filament and takes 182 minutes.