Dual Yanagi Case
Dual Yanagi Case
Published 2018-09-06T15:04:27+00:00
A dual case for Yanagi kitchen knives. I found these a a thrift store and they didn't have a case and i wanted to keep them together as brothers lol, so i made these crude yet functional cases that house them both. If you want to use the handle, print it along with yanagi case A & B, but both knives won't fit into the case anymore. Perfect for if you only have one yanagi though :)
- 100% infil
- .2mm layer height
- PLA
- 300mmx300mm build plate printed diagonally
- Super glue A to B, let dry, then glue C
- I had to boil a kettle of water and slowly insert second knife into case C as i poured water over the case while other knife was fully inserted into case A, as to thermoform the case. But printing case C @ 105% scale should let you avoid that process.
- Use extreme Caution using the thermoform method as it's boiling water and the razor sharp Yanagi may slip or case might split open and cause severe injury if not properly glued and dried.
Date published | 06/09/2018 |
Supporto Gratuito | YES |