This is my second entry for the Esso 250ml can contest. This is a desk lamp. I needed a lamp for my desk and was trying to find a lamp like this that was affordable. I then had an idea! The base is designed to be printed in vase mode. There are 2 seperating rings and a cap for the cans to be made. the arms are hollow to run the wires to the lamp shade. Cut the top and bottom of 2 250ml cans and then cut and glue them shiny side out inside of the shades. The shades were split in half to allow printing on my I3 clone and then glued together. The arms thread into the top and there are 2 nuts to hold the shade onto the lamp. I havent printed this yet as I had a critical failure with my hotend extruder and am waiting on parts. Once printed I will update printing instructions.