DIY Brush Arrow Rest for Compound Bows (Using Toothbrushes)
DIY Brush Arrow Rest for Compound Bows (Using Toothbrushes)
Published 2020-08-21T10:45:13+00:00
Printed using an Elegoo Mars with ABS-Like Resin. FDM should work as well, though.
The brushes were taken from a popular brand (see pictures)
The connecting bolt needs to be attached to the arrow receptacle after printing. Super glue worked fine for me but adding a screw might be a good option for others.
Note the orientation of the fletching! I'll add a second variant soon.
--------------------
Update, August 24th 2020 :
Now, that I was able to try it on the range, I can say that it works nicely. The arrow cleared the rest and went into the target without noticeable deflection.
HOWEVER, PRINTING THE MOUNTING BIT (arrow_rest_mount.stl) IN RESIN WAS A POOR CHOICE.
After the arrow was released, the excessive vibrations of the bow destroyed the part.
I added a new variant and printed in in PETG, which should work much better. The part is called "Arrow_Rest_Mount_no_markings.STL" as the little notches can obviously not be achieved in FDM-Printing.
Date published | 21/08/2020 |
Supporto Gratuito | YES |