Drip Emitter V2 (No wings) - 3Dponics Emitters & Plugs
Drip Emitter V2 (No wings) - 3Dponics Emitters & Plugs
3D
Published 2015-07-14T15:25:38+00:00
Version 2 of the Drip Emitter is used to drain excess water from pots that have a hole at the bottom. It fits snuggly inside the hole--all you have to do is snap it into place. For an extra secure seal, you can use silicone around the edges. You can then connect a long piece of tubing to the end of the Emitter and direct it into a large container or reservoir, which will collect the excess water. The thicker nozzle allows for a better, tighter fit with the flexible tubing. Know how to make this part better? Have ideas for new parts? Visit our website (https://www.3dponics.com) and join our Google+ community (https://plus.google.com/u/0/communities/111638904033818784260) to take 3Dponics to the next level!
Want to know how much it would cost to print this part? Visit https://www.3Dprintler.com and compare prices from today's top 3D-printing services.
Print at 0.2 mm layer height, with 10% infill. This uses 1g of filament and takes 11 minutes.
| Date published | 14/07/2015 |
| Quantità di filamento | 1g |
| Dimensioni | 20 x 21 x 20 mm |
| Complessità | Very Easy |
