Extreme CR-10s Fang Cooling
Extreme CR-10s Fang Cooling
3D
Published 2018-10-17T23:12:10+00:00
Manifestly adequate cooling! Get those overhangs you've always dreamed of. Stop your print head crashing into the parts where they've warped (most of the time).
* All 40mm fans for small profile.
* Two cooling fans for symmetric air flow with minimal ducting.
* 3 point attachment to back plate for zero movement.
* Designed to throw a lot of air at the problem.
* Fans mounted low and close to reduce twisting moments.
* Run the cooling fans at 50% for excellent cooling and near silent operation.
* Designed in parts for iterative design and easy printing with very little support required.
* Print a base, two ducts
* 0.3mm layers is fine.
* Use supports for the base, but no supports are required for the ducts as internal chamfers enable easy bridging.
| Date published | 17/10/2018 |
| Tempo per farlo | 90 - 120 Minuti |