Ender 5 Micro Swiss Direct Drive Kit - Dual 5015/4020 - BLTouch
Ender 5 Micro Swiss Direct Drive Kit - Dual 5015/4020 - BLTouch
3D
Published 2020-09-08T22:55:13+00:00
This is a replacement for the stock fan shroud when using the Micro Swiss Ender 5 Direct Drive kit. It allows use of a 40x20mm main fan and two 50x15mm part cooling fans, and a BL Touch.
- Easy to print
- No supports, each piece prints in 2hrs, estimated
- Easy assembly
- minimal hidden screws/nuts, tight fitting slots so they don't fall out while you're working on it.
- Easy maintenance
- Access/replace hotend by removing one fan.
- Lightweight
- minimal hardware and plastic, keep weight close to the carriage
- Maximize print area
- no loss on X axis, small (approx 10mm) on Y axis
- Secure
- no rattling fans, everything is solidly mounted, extruder and hotend mount metal-to-metal.
For best results, print brackets with the base-plate side down.
Bill of Materials
Fans
40x20mm Axial Fan - Noctua makes 5v and 12v ones, be sure to connect to the correct voltage source (the stock Ender 5 fan is 24v, don't use those connectors!)
50x15mm Blower Fan x 2 - I use the some Dual Bearing Low RPM/Quiet ones from amazon, be sure to get ones that match your machine's voltage--24v for Ender 5
Hardware
- 4020 Fan
- M3x20 Socket Head x 4
- M3 Nut x 4
- 5015 Fans
- M4x20 x 2 (Top)
- M4x22 x 2 (Bottom)
- can substitute with M4x25 with washers or printed 2.5mm spacer
- M4 Nut x 4
- Bracket Mounts
- M3x6 or M3x8 x 4
- M3x6 or M3x8 x 4
WORK IN PROGRESS
Left side with fan duct is not yet completed, should be done this week.
| Date published | 08/09/2020 |
| Supporto Gratuito | YES |