eyeT light
$1.99 eyeT light
3D
Published 2018-02-22T11:31:36+00:00
Hi, if you like this check out my other creations and support me here.
My wife loves t-lights, so I designed this stand to enhance them.
A large UFO like saucer cradels the tea light in the centre of the bowl like the pupil of an eye, giving unblinking light.
The t-light sits down in the middle of the saucer giving it protection from draughts, while the holes in the stand and saucer line-up to keep air flowing around to keep the stand cool and the flame constant, reducing flickers. Or you can use LED Tealights for peace of mind - they will fit too.
This prints in two parts and locks together and can not be reduced in size as a tea light only fits at 100%
- The eyeTlight has to print verticaly and at 45º to fit on a 220 x 220mm build plate, it also has a support stand built in that snaps off when finished, it falls over during printing without it.
- Print speed of 60mm/s gives a day and a half print time and increases the chances of a fall 40mm/s or 30mm/s is better.
- Layerheight 0.15mm
- Build plate adhesion - Raft
- Supports are a must
- Infil - I like Cubic
The eyeLight-stand
- Easy to print
- With same settings and 60mm/s speed 7 1/2 hr print time
Just rember to line up the holes in the stand and light for correct ventilation when you fit them together
| Date published | 22/02/2018 |
| Price | $1.99 |
| Tempo per farlo | 1830 - Minuti |
| Quantità di filamento | 201grams |
| Dimensioni | 205mm x 205mm x 110mm |
| Tecnologia | FDM |
| Complessità | Easy |