Gamora Belt Buckles Vol. 2
Gamora Belt Buckles Vol. 2
3D
Published 2017-10-02T17:54:25+00:00
This is Gamora's belt buckles from Guardians of the Galaxy Vol. 2. Each Buckle is designed in two parts for easier printing then glued together. They then just slide on the belt. I used screws through the back to lock them in place.Mine are a little small, because I scaled to the belt in the pictures and the belts I'm using are a little smaller.These were scaled to my wife's 30mm belt, so You will need to scale them accordingly. They should scale up just fine.The belt case is the only part that needs support for the belt loop indention. A little sanding will be needed for the belt loop to fit into the case. I did the best I could with images I found.This is my first designed and published model. I hope someone else finds it useful. Enjoy.
Buckle faces and belt case were printed at .15 Resolution. Belt loops were done at .2 20% Infill on loops, and 10% on the case.
| Date published | 02/10/2017 |
| Tecnologia | FDM |
| Complessità | Easy |