Googly Polypanels
Googly Polypanels
3D
Published 2019-05-19T08:05:15+00:00 • Remixed from Polypanels // Square, Polypanels // *Snaps Only*, Googly Eyes // 1 inch
Make Anything's polypanels, now with Make Anything's googly eyes (or at least googly pupils). This provides the inner part of a standard square polypanel, to be used with the googly pupils from the 1-inch googly eyes (the 1.5-inch ones are a bit on the large side), and the polypanel edge from the square polypanels. I've included these in the download for convenience, or you can get the originals from:
https://www.myminifactory.com/object/3d-print-polypanels-square-89425
https://www.myminifactory.com/object/3d-print-googly-eyes-1-inch-93764
The inner panel is 2 mm thick, for use with an edge-only panel. The alternative inlay panels are 1.2 mm thick, and fits in a standard solid or open panel (standard square for the eyes, half-size square for the teeth).
Note that the tabs that holds the pupil part are about 0.6 mm thick. Be careful when removing the print from the build plate. I printed my panels with 0.15 mm layer height, but it probably works with 0.2 mm too.
For more on polypanels, see makeanything.design/polypanels.
| Date published | 19/05/2019 |
| Supporto Gratuito | YES |