Gyver Lamp-Charging Station
Gyver Lamp-Charging Station
3D
Published 2020-07-29T12:40:58+00:00
GyverLamp - my reincarnation of a popular project: a lamp bottom base, a cap and ESP8266 module holder designed for a Plastic Lampshade that you can by at Ali (search for Gyver Lamp).
I use a 5v 2.5A power supply (also bought at Ali, just search for 2.5A power supplies from disassembling) and an ESP82266 module on a white board...
The lamp can be also used as a charging station for your smart phone when the lamp is not used: 2.5A power supply is good enough to serve as a charger. So, I've added a USB connector.
Still, 2.5A power supply can support both charging a smart phone and the lamp running in low brightness modes (like Flame, Matrix, or Snow modes)... Otherwise 2.5A could not be enough to run both...
Link to firmware: https://github.com/AlexGyver/GyverLight
If you like my design, please, consider making a small "cup of coffee" donation using PayPal
| Date published | 29/07/2020 |