Lithophane Monument
5,247
views
339
downloads
4
collections
0 comments
Loading comments...
Lithophane Monument
3D
Published 2019-01-20T08:35:21+00:00
46
0
Add to Collection
Description
This is a 3 Panel Lithophane display with an LED light inside. The lithophanes are 3mm thick and 97mm wide by 104mm tall. This model needs no supports and the other parts used will be linked below. The filament I used in the photos above is ZIRO Marble Filament.
Lithophane Maker Light Cord LED Bulb
Instructions
- Print all parts paying attention to Lithophane required dimensions. 3x97x104mm
- Put light socket through bottom base hole from the outside to the inside and insert it into the light holder
Hot glue light socket to the light adapter and glue the light adapter to the base - Assemble by putting the top of the model on, you may have to sand the columns very lightly to make them fit. You may use a couple small dabs of hot glue to keep the top on if necessary.
Technical Information
Date published | 20/01/2019 |
Supporto Gratuito | YES |
More Information
Object Parts