Merchant Dice Tower - SUPPORT FREE!
$6.99 Merchant Dice Tower - SUPPORT FREE!
3D
Published 2021-03-22T09:21:40+00:00
Merchant Dice Tower!
**Check out my newest Kickstarter campaign, Furhaven! A family friendly 5e compatible RPG! (3D Printables available too!) >> http://kck.st/33FAsmD
I created this dice tower for my Kickstarter campaign: Fates End! This Dice Tower is designed to work with typical 16mm (based on D6) dice sets. The D20 in that set is 20mm. If you want to print this tower smaller, you can print it at 60% for tiny 10mm dice sets.
This set of files includes a single version of the dice tower, and a version split into two parts for easy printing on Ender3, Prusa Mini and similar printers. (Two part = DT2_Top + DT2_Btm)
*Please note: due to its unique nature, there are no additional trays for this tower.
*Non-commercial License. Please don’t sell prints of this file, you’re welcome to give them away as gifts though.
For more details, please visit:
No Supports! Print at 100% for rolling regular-sized dice sets. (16mm based on the D6.)
Instructions:
The longer axle goes in the front, the shorter one in back. The smaller wheels go in front, larger wheels go in the back.
To install the wheels, insert the axle clips through the wheels where the rectangle cut out is tallest/widest. Rotate the entire wagon 90 degrees, then press the second wheel into the clip from the top (this is awkward if you try it with the wagon sitting upright.)
The wheels are there for decoration, they can roll, but there’s a lot of friction resulting in a jolting motion. If you want it to roll a little more smoothly, I’d recommend gluing the axles and wheels together and either rolling it on a surface such as a mouse pad or covering the wheels with a rubbery material to reduce friction, allowing them to move more freely.
| Date published | 22/03/2021 |
| Price | $6.99 |
| Supporto Gratuito | YES |
Stunning, absolutely stunning model but I expect nothing less from this amazing artist. Third dice tower I've printed by Kim and the third I've loved. Thank you!