My take on Corona Virus Coronavirus Covid-19 NO SUPPORTS (Assembly Required)
My take on Corona Virus Coronavirus Covid-19 NO SUPPORTS (Assembly Required)
3D
Published 2020-03-22T18:15:29+00:00
This is my interpretation of the COVID-2019 Coronavirus. Being stuck at home because of this stupid thing, I decided to make a macro plastic version of it.I took inspitation from images online of the corona virus and https://www.myminifactory.com/object/3d-print-coronavirus-optimised-one-piece-covid-19-113863 but this is not a remix, it is a from scratch design. I dislike supports and I also wanted to make a multicolor version without a multi material printer, so I set to work and designed this thing.
This is very easy to print even on a very small printer. The body is 50mm in diameter and the spikes are a little over 20mm. You will need to print 2 body halves, 1 pin and 45 spikes. I used a brim on the spikes and set the printer to ZHop as not to knock the spikes over while printing. I used some adhesive for car trim to hold it together, but 3d gloop,or super glue, or even hot glue would work fine to assemble it. I printed this in translucent blue PLA and red PLA.
It is a little cartoony in it's dimensions, but it is a good reference piece. I think it would be a good project for all those kids who are out of school during the pandemic shutdown.
I promise that printing this will not infect you with the Virus! Wash your hands and be careful out there!
I sliced this in Cura with .15 layer height with variable layer height on. I put on an 8mm brim for the spikes (and accidentally left it on for the body and pin) I used a 10% infill
I used cheap translucent blue PLA and Zyltech Red PLA to make this.
| Date published | 22/03/2020 |
| Dimensioni | after assembly it is approximately 80mm in diameter |
| Supporto Gratuito | YES |