Nerf Hive Box - hexagonal darts container
Nerf Hive Box - hexagonal darts container
3D
Published 2020-01-03T18:33:30+00:00
This is a box with hexagonal elements for 127 Nerf darts.
The box is optimized for darts with 73.4mm length and 12.7mm diameter.
Printing time with my Ender3: 24h for the bottom and 12h for the top.
I used CURA for slicing with "generic PLA" material and "fine" settings.
Using 0.2 is a good layer thickness value.
No supports or plate adesion are needed.
Pay attention.Stringing can be very annoying. It happened to me because of bad settings and I had to carefully remove the very strong unwanted thin surfaces created between some hexagons vertices. This operation was mandatory since the sharp edges of theese strings of material were damaging the darts.
The width of the internal hexagonal cells dividers is 0.3mm by design. Hence, the resolution selected on the slicer SW must be equal or greather than 0.3mm, otherwise the box will not be printed correctly
| Date published | 03/01/2020 |
| Tempo per farlo | 20 - 36 Minuti |
| Supporto Gratuito | YES |