Orange Pi Blade
Orange Pi Blade
3D
Published 2020-02-24T19:37:40+00:00
SBC Blade System
Objective
The Objective of this project is to design a modular "blade style" system for different single board computers (SBC).
I am starting with an Orange Pi PC 2, and will eventually move to other SBCs, while keeping the enclosure intact.
Standards
The case will be powered by a single power supply, and each blade will bring the voltage down to whatever voltage they need.
The connector for the backplane will be a D-Sub connector with 9 pins, this makes it easy to push and pull to connect and disconnect respectively, and opens the chance for future communtication with the enclosure.
V1
A blade's dimentions are 120x70x30mm
This can be pretty retract intensive, so make sure your printer is well calibrated :)
| Date published | 24/02/2020 |
| Dimensioni | 120mm x 75mm x 30mm |
| Supporto Gratuito | YES |