Parking Garage
Parking Garage
3D
Published 2019-12-22T16:45:17+00:00
This model of a parking garage is intricately designed and easy to print. It features many details, from the parking garage entrances, the small lot in front, 5 separate levels, and an elevator. Because of the way this file is printed, no supports are required and you can fully see inside of the parking garage!
If you enjoy this design, please check out this collection of architectural models that are easy to print and full of details:
https://www.myminifactory.com/users/AlexTStudios/collection/architecture-collection
Print this at 0.4mm walls, 0.6mm floor / ceiling, and 25% infill for maximum strength. This model is printed in 8 parts, which you have to superglue together after printing.
First, glue the roof of the parking garage entrance on as shown in the picture. Then glue the five parking garage levels together, with the entrance at the bottom. Glue this parking garage onto the main print, making sure to align it with the elevator. Finally, glue the wall of the roof to the top of the parking garage, and you are done!
| Date published | 22/12/2019 |
| Supporto Gratuito | YES |
