Riddler Trophy - Batman Arkham Asylum
Riddler Trophy - Batman Arkham Asylum
3D
Published 2020-03-27T18:40:12+00:00
Probably the most iconic game prop in the entire Batman Arkham franchise, when I saw the official version I desperately wanted one but they were expensive and hard to find.
Sometime later I got around to modeling the trophy and printing one and this is what I came up with. It may not be the best way to build one but it's how I got it done.
It was designed to use stripped elwire that runs through channels in the question mark. Theres a compartment underneath to store electronics and a pathway to route the cables from the compartment to the lamp holder. You can reference this short video I took a while back to see what I mean by stripping the elwire.
VIDEO: https://youtu.be/ahcQ8vJMmAA
RECOMMENDED MATERIALS:
El-Wire Green - https://amzn.to/3btooTQ
PLA Green - https://amzn.to/2JmqybM
PLA Silver - https://amzn.to/3dzTFq4
Raise 3D Printer - https://amzn.to/3aqoH1t
Soldering Kit - https://amzn.to/2UCexnU
Acrylic Paints - https://amzn.to/39mLNFc
Bob Smith Super Glue - https://amzn.to/3aqG5Dg
NOTE: Some aesthetic and minor improvements were made to the design since some of the photos were taken nothing major.
Recommend printing high infill and perimeters for the base maybe 30% infill so its heavy and less prone to knocking over.
| Date published | 27/03/2020 |