I like vampires, but these Werwolfs looking so powerfull! Great! :)

Printed like a charm with the pre-supported model, I just love the quality of these high details sculpts!

Fresh off the print and clean, not even cured yet. Printed with Elegoo Mars 2 Pro at 0.025mm layers at 150% with Water Washable Elegoo Beige resin. Setup, supported and sliced in Lychee. Settings: Elegoo Mars 2 Pro Printer in Lychee, 35 sec bottom layer exposure at 5 layers, 3 sec normal layer exposure, no light-on or off delay, 5mm print up/down, 100mm up/down speed.