These files were designed to fit in Ultimaker (dual extrusion) at 100% scale. Each tile size is 2 x 2cm. I recommend to print "3rd Set : 2 blank tiles" first. It should take about 20min at 0.2mm layer height. When two blank tiles are printed properly, then print 1st & 2nd set which will take about approximately 10hrs at 0.2mm layer height per set.

INSTRUCTION
- Open one set (two files) in CURA at the same time.
- Match the core colors (for my print, I placed white PLA in core1 & blue PLA in core2)
- Merge two files into one
- Rotate the model 180 degree (flat surface with letters should face down)
- Make sure the xyz coordinates at 0,0,0
- Save as .gcode

1st Set : 49 Letter Tiles from A-L
letter tiles (A-L)_core1_white
letter tiles (A-L)_core2_blue

2nd Set : 49 Letter Tiles from L-Z
letter tiles (L-Z)_core1_white
letter tiles (L-Z)_core2_blue

3rd Set : 2 blank tiles
blank tile_core1_white
blank tile_core2_blue

Scrabble tile letter distribution is as follows (100 tiles in total)
A-9, B-2, C-2, D-4, E-12, F-2, G-3, H-2, I-9, J-1, K-1, L-4, M-2, N-6, O-8, P-2, Q-1, R-6, S-4, T-6, U-4, V-2, W-2, X-1, Y-2, Z-1 and Blanks-2

Instagram @sparkroom