1sd15's Print of Filament Guide, Filament Cleaner and Cable Clip 3-in-1 for Creality CR 10, Ender 3 and Ender 2
Community Print 3D Print of Filament Guide, Filament Cleaner and Cable Clip 3-in-1 for Creality CR 10, Ender 3 and Ender 2
Published 2019-04-08T18:08:36+00:00
10
0
Printed on: Creality Ender 3
Material: PLA
Description
Works well! Printed it out and installed it thinking that it might be tight around the Z but it fitted perfectly. Unfortunately I had to remove the end of the extension as the support was stuck. That was probably my fault for using an automatic splicer. Wire holding works well too, and despite losing the bolt and searching for an hour, it was successful.