Easter Tomb
Easter Tomb
3D
Published 2020-04-06T16:41:15+00:00
This design is based on information from this article:https://www.thegospelcoalition.org/blogs/justin-taylor/what-did-jesus-tomb-look-like-interview/
It is 1:20 scale with a removable top and a stone that rolls in front of the entrance.
Timelapse:https://www.youtube.com/watch?v=RVUeKb1zEls
When I printed the base, I added some extra support under the internal corners by using Cura's support blockers and changing them to modify the infill. I put one under each internal corner. For the ramp section in front where the stone goes, I did something similar but just included the entire section. You can see it all in the timelapse if you look closely.
I recommend using adaptive layers. For me, 0.12-0.28 worked on my Ender 3.
| Date published | 06/04/2020 |
| Support Free | YES |