Apimaye Bee Hive Small Hive Beetle Blocker Entrance Covers
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Apimaye Bee Hive Small Hive Beetle Blocker Entrance Covers
Covers to reduce ease of entry of small hive beetles into Apimaye beehives.
***The lower entrance covers remove the ability to seal the hive closed.***
These designs are based on some beetle blocking designs I have seen around, but made to fit on Apimaye equipment. I have started to get quite a few of the Apimaye hives and after making this for myself, I wanted to make these parts available for other Apimaye users.
The numbers in the "slider" file names correspond to how many entry/exit holes are left open when the beetle guard is in place. One hole is the least and three holes are the most, and both left and right models are provided.
All models are positioned in my preferred printing orientation, and I clean up the hard overhangs' plastic with a hot knife afterwards.
Check out these standard replacement parts for Apimaye hives to make alternate colored entrances!
These are designed for the 7 frame version of Apimaye equipment, so they are unconfirmed as far as fitting the ten frame hive.
Thanks for looking.
Supports recommended for all models.
Model print time ranges from 2.5 hours to 3.5 hours and requires from 18g to 23g of filament based on my experience.
Status | Rejected |
Material Quantity | 23g |