Tackle box style Jumper wire container
Tackle box style Jumper wire container
3D
Published 2020-07-20T12:23:43+00:00
This is a sort of folding box for storing jumper wires or small bits and pieces.
It has a little bit of assembly required but not to much.
When you go to print this box you may notice there are some files that have built in supports. this is due to me being unable to get my slicer to generate supports for the small nubs sticking out of the sides of the bins, so I desinged some built in supports with 0.3mm gaps between them and the part.
For assembly you will need some sort of glue, I used super glue.
With the bins stacked ontop of eachother with nubs on the top bins towards the middle; you will want to take an arm and place it over one of the nubs and then the other nub on the bin above it at an angle(I am bad at explaing, but you should be able to figure out what I mean with the pictures). Once you have placed on all the arms, you can then take the end caps and you will need to use a little bit of glue to attach them to the ends of the nubs as shown in the picture with the purple and green dot. After that you should be able to use the box :D
| Date published | 20/07/2020 |