2019 Deckard Sedan
2019 Deckard Sedan
Published 2022-01-11T09:37:42+00:00
The 2019 Deckard Sedan
A decommissioned police Aerodyne retrofitted to ground mode.
NOTES:
I separated the front wheels to minimize distortion while printing. You'll need to print two copies of the wheel model and glue them in place.
I hollowed out the underside of the vehicle to save on resin/filament.There's enough room underneath to add in some LEDs if you're so inclined.
I have not included a supported version as its a fairly large model and you might prefer a different print orientation depending on your printer. I rotated the model 25 degrees with the rear facing up and added supports underneath.
I have only printed this out in resin so far, but I'm sure that with some proper orientation it will print just fine on an FDM printer with minimal supports.
Modeled in Fusion 360
Sliced and supported in Chitubox
Printed on Elegoo Mars 2 Pro with Elegoo water washable transparent green resin
Date published | 11/01/2022 |